電力要求

電源爲電壓 220V，頻率 50HZ 的交流電，電壓波動範圍小於 10﹪，電壓波動若大於 10﹪時，必須使

用穩壓器。

1Power and environmental conditions:

10%, must be equipped with power voltage.

Power into line according to provisions of fixed and safety protective measures, can't bear any reaction.

The equipment must be connected grounding wires, grounding bad will cause personnel electrical shock and affect the safety and reliability of the products of the operation.

Prohibit direct input/output loop controller insulation test, otherwise will directly cause electrical equipment damage.

't debris piled up, so as to facilitate the heat dissipation and should be regularly clean dust.

Stop the operation of electric equipment in damp, dust, corrosive gas, inflammable and explosive gas place, otherwise it may cause personnel electric shock or fire.

2 Comply with the following specification when make machine maintenance or machine repair:

Forbid unprofessional person check and repair, avoid to expand the fault even causing injuries and property losses.

Prohibit the electrical professionals to electrical parts repair, commissioning, avoid to reduce the safety equipment performance, expand the fault even causing injuries and property losses.

When the machine is running,, must ensure that in the situation of power, to ensure operation safety of personnel.

Malfunction should by professional personnel to check and repair, and follow this manual repair norms.

Change control cabinet inside of electrical components, must ensure that in the situation of power, to ensure operation safety of personnel.

Instead of using the company provides the spare parts, extremely easy to cause fire, electrocution and seriously damaged consequences.

Please strictly according to the product specification replacing the fuse the marked, so as to ensure the safety of personnel and property.

.

11 After machine maintenance, please keep the parts have been moved  back to correct position.

12 In order to keep machine running well,.

13  Please stop machine run before machine parts test in a power-on state, and adjust to the relevant test menu, then start the test work.

3 Machine operation should observe followed specification :

• Don’t opera chine before understand  machine well.
• Before starting the machine machine at boot, please pay attention to machine the periphery other personnel, prevent the occurrence of harm!
• Operator with lone hair must put the hair up,and ensure hair no hanging during the work , avoid your hair be nipped by the machine carriage in running state.
• Don’t wear the cloth or jewelry with thin and long accessory ,avoid be nipped by the machine carriage in running state.
• Before starting the machine machine at boot, please check the needle bed knitting pressure ruler, choose sutural pressure ruler and choose sutural whether is in the correct position to ensure that each a medal for knitting and choose the pins were pressure feet, and choose the pins pinned the tail not bulge needle bed 0.5 mm!
• Second-ranking machine run , the operation of the carriage might hit the operators and make it hurt!
• When machine running abnormally, please stop machine, and consult our service person.
• Second-ranking machine in energized, forbidden to open the back part of the electrical box machines, lest electric shock risk!
• Don’t use machine when thunderstorm weather, avoid machine damaged.
• Avoid machine long time running unattended .